Suggest for driving only High FETs or only Low FETs

1

Hi,
I have a question I did a card using EPC23101 with the EPC2306 but I cannot use only the high FET or only the low FET, I should always be switching between the two FETs.
Do you have any suggest even if i can use the driver seperate from the FET, because I want to use a multilevel inverter.
Thanks a lot.

2

Hello.
The EPC23101, '102, '104 power stages have an inherent limitation on the timing. The maximum Ton of Toff is 200 us, so each of the FETs needs to switch at >5 kHz. See datasheet for further details.

A discrete solution with gate driver IC + discrete FET like EPC2367 is recommended.

Best regards