I’m currently using the EPC23104 as a buffer to turn on and off another device. I’m providing the Signal to the EPC23104 at 5V and the Output supplied between +15V and GND. Rdrv and Rboot =1 Ohm, Cdrv and Cboot = 100nF, as suggested from datasheet. Furtnermore, as can i would ahow you from a picture, I have an undesired turn on at the second pulse (the first pulse is fine). Do you have any suggestion? It might be related to the low voltage I’m currently working? This behavior has been experienced without any other voltage applied, only the +5v for the signals and the +15V .
Hi Stefa,
We understand your question but still hope to have deep discussion into your condtion.
Would you mind sending your remail to my contact : pei-cheng.huang@epc-co.com
We will have a deep conversation with your project.
BEst Regards
PEi